Casablanca Fan Company 32xxA Ceiling Hardware, Support Installation Parts, additional hardware

CEILING HARDWARE

CROSSBAR	WIRE NUT (4)
MOUNTING
BRACKET

additional hardware

21/4” x 8-32 rounded head screw (2)

1” x 8-32 rounded	FLAT WASHER
head screw (2)

SUPPORT INSTALLATION PARTS

LAG SCREW	LARGE
	FLAT WASHER
3/8” #7 X 5” (1)
	3/8” (1)

CROSSBAR MOUNTING BRACKET INSTALLATION

Note: After removing the old fixture, check the outlet box to insure that it is supported by a joist or beam across its upper surface. If not, a 2” x 4” stud must be installed.

Step 1. Remove the knockout plug in the center of the out- let box or drill a 1/2″ hole for the lag screw to pass through. Then drill a 1/4″ guide hole into the joist or beam to a depth of 3″.

Step 2. Route the outlet box wires through the keyhole slot of the crossbar mounting bracket as shown. Attach the crossbar mounting bracket to outlet box with screws provided, assuring that the outlet box wires are not pinched by the washer.

CAUTION: To reduce the risk of personal injury, use only the mounting hardware pro- vided with the approved outlet box to install the crossbar mounting bracket.

WARNING!

SUPPORT DIRECTLY TO

BUILDING STRUCTURE

ONLY.

JOIST

ceiling fan

approved

wiring box

crossbar mounting bracket

flat

washer

approved out-

let box

hardware

ceiling wiring

ridge

side

down

green

ground

wire

4