ADVAN•TOUCH®
advan•TOUCH BATTERY INSTALLATION
Open Battery Door | Install 4 | “AAA” alkaline | |
by pressing down on | batteries | in | the space |
the insert tab pro- | provided. Please observe | ||
vided. | proper polarity | placement. | |
| Replace Battery | Door. | |
Battery
Door
advan•TOUCH important operating notes
Power turned off, interrupted or failure:
The remote control is battery operated, therefore if the power is turned off, interrupted or you experience a power failure, the remote control remembers the previous setting for both fan and light.
Button operation:
Rapid button operation causes erratic fan operation.
For reliable operation of the remote control and fan you must wait one second between button presses to allow the radio signal to be transmitted to the fan and received.
advan•TOUCH Operation
Fan Operation
The Advan•Touch fan is controlled by the remote control. The fan button located in the center top row, turns the fan on or off.
With the fan on, the control display will indicate an up or down moving arrow that shows direction and places a box around the operating speed. It will also show you a moving fan image that tells you the fan is on and what direction the blades are moving in (looking up from underneath the fan).
Just below the fan button, there are two 
and 
buttons. Use the 
button (on the left) to increase fan speed once for each press and the 
button (on the right) to decrease speed once for each press.
Use the reverse button to change the direction of the rotation. Reverse operates at any speed. The fan returns to its set speed after reversing. You will see the airflow direction arrow change each time to press re- verse.
Light Operation
The light is turned on or off independently of the fan by pressing the LIGHT button. Keep pressing the button (hold it down) and it becomes a dimmer. The light varies from “bright” to “dim” over approximately 8 seconds. This sequence will reverse the light when it reaches the brightest or dimmest level if you continue to hold the LIGHT button. Release the button when the desired level is reached.
Safe Exit Feature
To turn off the light, hit the button once and the light will increase slightly if less than 100% and gradually turn off, taking approximately 20 seconds. (If set at 100%, light will decrease to about 50% and then gradually turn off.) This enables you to leave a room or your home safely before the lights go completely out.
Push the light button two times and the light will immediately dim to about half and then turn off completely.
The fan will remember the last light setting and will come on at that set- ting until charged.
Bulb Saver Feature
When the light is turned on, the brightness will take 1.5 seconds until it reaches the present level. This feature helps extend light bulb life.
13
