Victorian®
INSTALLATION INSTRUCTIONS
Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.
Note: Only one set of blade holders is supplied. Depend- ing on the fan model and series they will be either the Commodore Style, the Center Style, the Badge Style with matching badges, or the Standard Style blade holder.
perma•lock™ hardware
ALLEN SET SCREW
downrod & Ball
3mm
assembly
allen wrench
Fan preparation
important safety information! |
| motor | |
before starting the installation of your ceiling fan, install the | |||
wires | |||
threaded downrod into the motor coupling and lock the assembly | |||
ground | |||
|
| ||
Prepare for fan installation as follows: |
| wire | |
Step A. Route the wires from the motor through the |
|
| |
Perma•Lock™ downrod and ball assembly. |
| downrod | |
Tip: The downrod has a tapered thread |
| & Ball | |
| assembly | ||
that is designed to lock completely when |
| ||
|
| ||
correctly installed. |
| tapered | |
Step B. Using the provided allen wrench, loosen the set screw |
| ||
| thread | ||
several turns to allow installation of the downrod. Thread the |
|
| |
downrod into the motor coupling until it stops turning, this |
|
| |
will take at least four and a half full turns. | ALLEN |
| |
Step C. Securely tighten the set screw with the provided allen | SET SCREW |
| |
|
| ||
wrench to ensure safe operation of your fan. |
| motor | |
coupling
CAUTION: Failure to fully lock in the down- rod before securely tightening the set screw may cause the fan to separate from the downrod during normal operation!
CEILING HARDWARE
CROSSBAR MOUNT- WIRE NUT (4) ING BRACKET
additional hardware
21/4″ x
1″ x | FLAT WASHER (2) | |
head screws (2) | ||
|
getting started
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish to place your Casablanca fan, an approved ceiling fixture outlet box must be installed and wired.
Warning: To reduce the risk of fire, electrical shock, or personal injury, mount to outlet box marked ac- ceptable for ceiling fan support using the mounting hardware provided with the outlet box.
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit breaker or fuse box), lower the old fixture and disconnect the wiring. Check the ceiling fixture outlet box to be sure that it is marked ‘Approved for ceiling fan mounting’. If it is not, a new box must be installed.
3
