Casablanca Fan Company 63XXT PROBLEM POSSIBLE REMEDIES, TROUBLESHOOTING, INTELITOUCH

Inteli•Touch®

Caring for Finishes: For cleaning, a soft brush or lint-free cloth

shouldbeusedtopreventscratchingthenish.Avacuumcleaner

brushnozzlecanremoveheavierdust.Surfacesmudgesor anac-

cumulationofdirtanddustcaneasilyberemovedbyusingamild

detergent and slightly dampened soft cloth. An antistatic agent

may be used, but neveruseabrasivecleaningagents.These will

damage the ﬁnish. Painted and high-gloss blades may be cleaned

in the same manner.

Blades: Wood ﬁnish blades should be cleaned with a furniture

polishing cloth. Occasionally, a light coat of furniture polish may

be applied for added protection and beauty.

Never Lubricate this Fan!

The precision motor at the heart of your Casablanca fan features

sealed bearings that are lubricated for life. Do not attempt to oil

the motor.

Changing Light Bulbs

Be sure to turn power to the fan OFF at the wall switch or circuit

breaker before changing light bulbs. Replace bulbs with same type as

removedfromthexture.Eachfanisratedfora maximumTOTAL

wattage of lighting.

Exceedingtheratedmaximum allowablewattagefor thefanwill

burnoutthefanelectronicsmoduleandvoidthewarranty.

NO FAN OR LIGHT Check main circuit fuses, curcuit breakers, or wall switch position. Check all wire connections, making

sure the power is turned off during this inspection.

FAN WOBBLES OR SHAkES Be sure canopy pin is properly set into the slot on the ball

EXCESSIVELY Check the screws holding the blade holders to the fan motor. Tighten as necessary.

Check the angle of the blades to make sure that a blade holder has not been bent during installation.

FAN NOISY DURING Checkandtightenlightxtureretainingscrews,glassshadescrewsand/orthelightbulb(s).

OPERATION Tighten canopy screws and mounting plate assembly.

 Tightenthebladetobladeholderscrewsandbladeholderstoywheel.

 Makesureallscrewsinthemotorhousingaresnug,butnotoverlytight.

Check that the wire nuts inside the canopy and switch housing are not touching the metal parts or

havefallenoffthewiresplices.Tightenoradjustasnecessary.

BREAK-IN PERIOD Letfanrunathighspeedfortwo(2)hours

DOES NOT RUN ON Ifnew,“break-in”mayberequired-runathigherspeedforseveraldays

LOW SPEED

LIGHTS FLASH OR BLINK DURING OPERATION OF W-32 WALL CONTROLS/FAN MAY ROTATE OR MAKE

AUDIBLE TONES DURING OPERATION OF THE W-32 WALL CONTROLS: Normal operation.

WHEN AC POWER IS TURNED ON FOR THE FIRST TIME, THE LIGHTS OPERATE NORMALLY, BUT W-32 WALL

CONTROL OPERATION IS REVERSED: FAN BUTTON OPERATES THE LIGHTS; LIGHT BUTTON OPERATES

THE FAN: Reversethe2blackandwhitestripedwireconnections.

FAN OR LIGHTS APPEAR TO OPERATE BY THEMSELVES (CHANGING SPEED OR INTENSITY), WALL CON-

TROL OPERATION IS INTERMITTENT: CheckACsupplyforirregularities,(noisespikes,uctuations,orfailure);orcircuit

board assembly.

PROBLEM POSSIBLE REMEDIESTROUBLESHOOTINGINTELI•TOUCH