Casablanca Fan Company 66HXXF Troubleshooting, Problem, Possible remedies, Necessary, Bulb

Panama® Halo

Troubleshooting

Before Requesting Service:

Please follow this troubleshooting guide before contacting your dealer for assistance.

Caring for Finishes: For cleaning, a soft brush or lint-free cloth should be used to prevent scratching the finish. A vacuum cleaner brush nozzle can remove heavier dust. Surface smudges or an accumulation of dirt and dust can easily be removed by using a mild detergent and slightly dampened soft cloth. An antistatic agent may be used, but never use abrasive cleaning agents. These will damage the finish. Painted and high-gloss blades may be cleaned in the same manner.

Blades: Wood finish blades should be cleaned with a furniture polishing cloth. Occasionally, a light coat of furniture polish may be applied for added protection and beauty.

Problem

Never Lubricate this Fan!

The precision motor at the heart of your Airflow fan features sealed bearings that are lubricated for life. Do not attempt to oil the motor.

Changing Light Bulbs

Be sure to turn power to the fan OFF at the wall switch or cir- cuit breaker before changing light bulbs. Replace bulbs with same type as removed from the fixture. Each fan is rated for a maximum TOTAL wattage of lighting.

Exceeding the rated maximum allowable wattage for the fan will burn out the fan electronics module and void the war- ranty.

POSSIBLE remedies..

FAN WILL NOT START •Check main circuit fuses, circuit breakers, or wall switch position. Check all wire connections,

making sure the power is turned off during this inspection.

•Pin connectors are not making good contact. Check the connections in the switch housing and under the top cover.

•Battery weak - install fresh battery. •Fan receiver defective - replace.

•Check receiver (fan) and transmitter (remote control) dip switch settings to see if they are both set to the same frquency.

FAN WOBBLES OR •Be sure canopy pin is properly set into the slot on the ball.

SHAKES EXCESSIVELY •Check that bladeholders have not been bent during installation and blades are balanced.

	•Hanger bracket and/or ceiling outlet are loosely attached: Make sure that the hanger bracket is
	tightly attached to the ceiling outlet box. Make sure that the downrod assembly is secured firmly
	•Downrod is loosely attached to downrod base: Make sure that all screws are securely tightened
FAN NOISY DURING	•Check and tighten light fixture retaining screws, glass shade screws and/or the light bulb(s).
OPERATION	•Tighten canopy screws and mounting plate assembly. Check that the wire nuts inside the canopy
	and switch housing are not touching the metal parts or have fallen off the wire splices. Tighten as
	necessary.
	•Tighten blade holders to flywheel (or direct drive motor)/and blade to bladeholder screws.
	•Make sure all screws in the motor housing are snug, but not overly tight. Defective bulb: Replace
	bulb.
DOES NOT RUN ON	•If new, “break-in” may be required - run at higher speed for several days.
LOW SPEED
BATTERY LIFE	•Not using Alkaline batteries: Replace with Alkaline batteries.
SEEMS SHORT

FAN RUNS SLOWLY IN EITHER DIRECTION IF ROTATION IS STARTED BY HAND; WILL NOT REVERSE:

Defective reverse switch; defective capacitor; or open motor winding: Replace reverse switch assembly; replace PCB assembly; or replace motor unit.

FAN WILL NOT OPERATE AT PROPER SPEEDS OR WILL NOT OPERATE AT ANY SPEED: Defective

three-speed pull-chain switch assembly; or defective capacitor: Replace three-speed pull-chain switch assembly; or replace PCB

9