®
Remote Operation
Fan Control
To start the fan. Press the selected speed button to run the fan at the desired speed.
LOW=Low speed MED=Medium speed HIGH=High speed To turn off the fan, press the FAN OFF button.
Airflow Direction
To reverse the airflow, press the REVERSE button. REVERSE operates at any speed whether the fan is on or off. The fan returns to its set speed after reversing.
Light Control
Turn the light on or off independently from the fan by pressing the LIGHT button. If you press the button for more than 0.7 seconds, it becomes a dimmer. The light varies from “bright" to “dim” over approximately 8 seconds. If you continue to hold the LIGHT button, this sequence will reverse when the light reaches its brightest or dimmest level. Release the button when the desired level is reached.
Memory Feature
The last light fuction and fan speed will resume when power is turned back on.
Auto Resume
Quick (pressing less than 0.7 seconds) on/off operation of the LIGHT button maintains the desired brightness level set previously.
Send Signal | Light | |
LED | ||
|
Med 
Low 
High
Reverse | Fan | |
Off | ||
|
ChangingTransmitter Frequency Setting
Note: All fans leave the factory set to “00000.”
You will only have to change the dip switch settings in the remote if you are using more than one fan in the same area and want to control them separately.
Step 1. At the circuit breaker or fuse box, turn the power off for the fan you want to change.
Step 2. Open the battery door of the Versa•Touch control and remove the batteries.
Step 3. Change the dip switch settings, assuring that they are different from the previously installed Versa•Touch fan.
Step 4.
Step 5. At the circuit breaker or fuse box, turn the power back on for the fan whose frequency you are changing.
Dip Switch
Set to “10000”
Versa•Touch 2
Control
(back)
Dip Switch
Set to “01001”
Step 6. Within 20 seconds of restoring power, push the High, Med, and Low buttons (in that order).
Note: You may want to label your controls to assure you do not mix them up.
If the fan is not functioning after installation:
Step 1. Check to make sure that batteries are installed cor- rectly in the control.
Step 2. Turn the power off to the fan (from the circuit breaker) for at least 5 seconds.
Step 3. Turn the power back on (at the circuit breaker) and push the High, Med, and Low
Step 4. The fan should now function properly.
warning!
Do not turn the power off at the circuit breaker,then back on, for the previously installed Versa•Touch2 fan(s), as you may inadvertently change the frequency settings for it as well.
| 2 |
|
| 3 | 1 |
Circuit | Press in this order to set | |
new frequency: | ||
Breaker | 1. High 2. Med | 3. Low |
or Fuse Box | ||
9
