Modena® II
INSTALLATION INSTRUCTIONS
IMPORTANT! Leave the fan in the carton until you are ready to hang the fan.
CEILING HARDWARE
|
| 1″ x |
|
| head screws (2) |
| WIRE NUT (4) |
|
CROSSBAR | lag screw and washer | FLAT WASHER (2) |
(1) |
| |
MOUNTING |
| |
|
| |
BRACKET |
|
|
getting started
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish to place your Casablanca fan, an approved ceiling fixture outlet box must be installed and wired.
Warning: To reduce the risk of fire, electrical shock, or personal injury, mount to outlet box marked acceptable for ceiling fan support using the mounting hardware provided with the outlet box. Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit breaker or fuse box), lower the old fixture and disconnect the wiring. Check the ceiling fixture outlet box to be sure that it is marked ‘Approved for ceiling fan mounting’. If it is not, a new box must be installed.
CROSSBAR MOUNTING BRACKET INSTALLATION
Proceed with installation as follows:
Step 1. To install the crossbar mounting bracket, route the outlet box wires along side of the crossbar mounting bracket. Attach the crossbar mounting bracket to the outlet box with the set of two
CAUTION: To reduce the risk of personal injury, use only the mounting hardware provided with the approved outlet box to install the crossbar mounting bracket.
Step 2. To install the lag screw, slide the remaining washer onto the lag screw. Pass the lag screw through the center hole in the crossbar mounting bracket. Se- cure the lag screw into the guide hole, tightening until the ceiling fixture outlet box is firmly mounted to the support beam.
Joist
Ceiling wiring
GREEN
ground
wire
Ceiling fixture
outlet box (ceiling fan rated)
Crossbar mounting bracket (ridge side down)
Washers
(2)
1” x
screws (2)
Lag screw
and
washer (1)
3
