Modena® II
fan preparation
Prepare for fan installation as follows:
Step 4. Route the wires from the motor through the Perma•Lock™ downrod and ball assembly.
Tip: The downrod has a tapered thread that is designed to lock com- pletely when correctly installed.
Step 5. Using the provided allen wrench, loosen the set screw several turns to allow installation of the downrod. Thread the downrod into the motor coupling until it stops turning, this will take at least four and a half full turns.
Step 6. Securely tighten the set screw with the provided allen wrench to ensure safe operation of your fan.
CAUTION: Failure to fully lock in the downrod before securely tightening the allen set screw may cause the fan to separate from the downrod during normal operation!
|
|
|
|
|
| ground | |
| Motor wires |
|
|
|
| wire | |
|
|
|
|
| downrod | ||
|
|
|
|
| & Ball | ||
tapered |
|
|
| assembly | |||
|
|
|
|
|
| ||
|
|
|
|
|
| ||
thread |
|
|
|
|
| ||
ALLEN |
|
|
|
|
|
| motor |
|
|
|
|
|
| ||
|
|
|
| coupling | |||
SET SCREW |
|
|
| ||||
|
|
|
|
| |||
WARNING! DO NOT REMOVE THIS LABEL AND TAMPER WITH
blade installation
Screw (3 per blade)
blade medallion
blades(5) (Set of 5)
Step 7. Take one blade and align it onto the blade iron of the fan. There is only one way it will fit. Align the blade medallion on to the blade and install the 3 screws per blade. Secure by hand only, do not use a power tool.
5
