INTELI•TOUCH © INSTALLING THE W-32 WALL CONTROL
The wall control installs in the same manner as an ordinary light switch, using an existing junction box and wiring. This controller is designed to signal the fan microcomputer as well as perform normal switching operations. For this reason the following precautions must be observed:
1. Use only the Casablanca
2. Do not use any additional control with your
INTELI•TOUCH ♦ SINGLE
CAUTION! Ensure power is turned OFF at the breaker or fuse panel before starting installation.
1.Remove the screws and switch plate from the existing switch box.
2.Remove the screws holding the switch in the switch box.
3.Pull the existing switch from the switch box to expose the wire connections.
4.Remove the two wires from the switch.
5.Connect the two wires just removed from the switch to the
6.Install the
7.Install the wall plate with the two color matched screws.
NOTE: If your wall control operation is reversed, i.e., fan switch controls lights and light switch controls fan, simply swap the two
SWAP THESE
TWO WIRES WHEN
NECESSARY
(SEE NOTE BELOW)
INTELI•TOUCH ♦DUAL W-32 INSTALLATION
CAUTION! Ensure power is turned OFF at the breaker |
| SWAP THESE TWO WIRES | ||
or fuse panel before starting installation. |
| |||
| WHEN NECESSARY | |||
|
|
| ||
To control the fan and lights from two locations |
| (SEE NOTE BELOW) | ||
|
| |||
(a |
|
| ||
1. | Remove the screws and switch plate from the |
|
| |
| existing switch box and the screws holding |
|
| |
| the switch in the switch box. |
|
| |
2. | Pull the existing switch from the switch box |
|
| |
| to expose the wire connections. |
|
| |
3. | Determine which wire is connected to the com- |
|
| |
| mon terminal of the |
|
| |
| terminal will be marked on switch). |
|
| |
4. | Remove the wire from the common terminal |
|
| |
| of the |
|
| |
| remaining black/white striped wire on the W- |
|
| |
| 32 control. Secure this splice with a wire nut. | END |
| |
5. | Remove the two remaining wires from the 3- | IN | ||
OF | ||||
| way switch. Connect one of these wires to a | LINE | ||
| LINE | |||
| black wire on the |
| ||
|
|
| ||
| splice with a wire nut. The remaining wire is |
|
| |
| to be connected to the other black wire on |
|
| |
| the |
|
| |
6. | Install the |
|
| |
| long screws provided. |
|
| |
7. | Install the wall plate with the two short color- |
|
| |
| matched screws provided. | NOTE: If your wall control operation is reversed, i.e., fan switch | ||
8. | Installation of the second | |||
controls lights and light switch controls fan, simply swap the | ||||
| tical. Repeat steps 1 through 8. | |||
| two | |||
|
|
12