4. Now try playing something on the keyboard.

•The lower range (left side) of the keyboard is assigned the split tone, while the upper range (right side) is assigned the main tone.

•The location on the keyboard where the changeover between the two tones occurs is called the split point. See “To change the location of the split point” on this page for details on changing the location of the split point.

5.Press the SPLIT button again to unsplit the keyboard and return it to normal.

•This causes the indicator lamp above the button to go out.

❚NOTE

•If you change or turn off a digital effect while split is turned on, the setting you make is saved to the main tone’s settings only.

How digital effects are applied when split is turned on

The following are the rules that determine what type of digital effects are applied to tones that are assigned to a split keyboard.

 

Cause these digital effects to

These conditions:

be applied to both the main

 

tone and split tone:

• Digital effects turned on

 

for the main tone

Main tone digital effects

• Digital effects turned on or

 

off for the split tone

 

 

 

• Digital effects turned off

 

for the main tone

 

• Layering turned on (page

Layered tone digital effects

E-13)

 

• Digital effects turned on

 

for the layered tone

 

 

 

• Digital effects turned off

 

for the main tone

 

• Layering turned on (page

 

E-13), but digital effects

Split tone digital effects

turned off for the layered

 

tone

 

• Layering turned off

 

• Digital effects turned on

 

for the split tone

 

 

 

428A-E-019A

To change the location of the split point

The “split point” is the point on the keyboard that separates the low range (split tone) from the high range (main tone).

1. While holding down the SPLIT button, press the keyboard key where you want the highest note (the rightmost key) of the lower range (left side range) to be.

•No sound is produced when the keys are pressed.

To adjust the volume of the split tone

1. Hold down the CONTROL button, and keep it depressed until you reach step 4 of this procedure.

2. Press the ELEC PIANO 1 button.

•This causes the indicator lamp above the button to flash.

3.Use one of the procedures below to set the split tone volume to a value in the range of 40 to 127.

•To scroll the volume setting value: While holding down the CONTROL button, use the + (increase) and

– (decrease) keys to scroll the volume setting value. Holding down either key changes the setting at high speed.

Pressing + and – at the same time automatically selects a volume setting value of 127.

•To input the volume setting value: While holding down the CONTROL button, use the number input keys to input a two-digit or three-digit volume setting value in the range of 40 to 127. You can input a two digit or a three-digit value. The level you input is applied to the volume setting value when you release the CONTROL button. The volume setting does not change if you input a one-digit value or a value that is outside of the allowable range.

B2 C3

+/– Number Input keys keys

•A note does not sound when you press a keyboard key at this time.

4.Release the CONTROL button to complete the procedure.

❚NOTE

•The setting you make for the split tone volume remains in effect even if you change to another tone.

E-15

AP38_e_08-19.p65

15

02.6.12, 15:55