Figure 4
(Back)A
B C
K
6
K
J
2Installing the Keyboard onto the Stand
Caution
Take care that you do not pinch your fingers between the keyboard and stand!
F
M
M
Figure 6
G
G
L
7
5.Attach back panel C to the F brackets and crosspiece D. Note that the back panel C should be installed so it is in front of the F brackets (Figure 4). Use the four M screws, six J screws to secure the back panel in place (Figures 3 and 4). Note that you must also install the second K clip at this time as shown in the illustration.
•First, install the topmost M screws on the left and right sides of the back panel C. Note that you should slip the other K clip onto the J screw at point 6 before you screw in the J screw.
•The back panel Cshould rest on the feet of side uprights A and B as indicated by 7 in the illustration. Press the back panel C against crosspiece D while installing the M screws.
Figure 5
H
6.Rotate height adjustment screw H until it supports crosspiece D, preventing the crosspiece from bending when you press the pedals (Figure 5).
IMPORTANT!
•Be sure to install adjustment screw H and perform the ad- justment procedure described above before depressing the pedals. Failure to do so can result in damage to cross- piece D.
L
Be sure that you securely anchor the keyboard to the stand using the L butterfly bolts (Figure 6).
•Slide the screws on the bottom of the keyboard into the slots in the two angle brackets G. Next, secure the keyboard to the stand with two butterfly bolts L (Figure 7).
Figure 7
G | Back | L |
Front
•The butterfly bolts keep the keyboard from falling from the stand. Be sure that you always secure the keyboard with the butterfly bolts.
36 | 02.6.12, 15:55 |