Casio CDP-200R Incorporating a Sampled Sound into a Drum Set (Drum Sampling), Applying Effects to a Sampled Sound, N o Da t a, N o D a t a, Press, Press, Press, 3.Press

Sampling Sounds and Playing Them on the Digital Piano

Applying Effects to a Sampled Sound

You can apply various effects to sampled sounds.

1.Press bt and then use cl (10-key) to enter the tone number (671 to 675) to which you want to apply effects.

2.Press bt to cycle thorough the available effects, described below.

Effect Type	Description
(Display)
Original (Orgnl)	Normal sampled tone (no looping, no
	effect).
Loop 1 (Loop1)	Loops the sampled sound.
	Loops the sample sound and raises the
Loop 2 (Loop2)	pitch of the resonating sound when the
	keyboard key is released.
	Loops the sample sound and lowers the
Loop 3 (Loop3)	pitch of the resonating sound when the
	keyboard key is released.
Pitch 1 (Ptch1)	Changes the pitch from low to high, at an
	increasing rate.
Pitch 2 (Ptch2)	Changes the pitch from high to low, at a
	decreasing rate.
	Changes the pitch from high to low, at a
Pitch 3 (Ptch3)	decreasing rate, and then raises the pitch
	when the key is released.
Tremolo (Treml)	Alternates volume between high and low.
Funny 1 (Funy1)	Adds vibrato and changes the pitch by a
	gradually increasing amount.
Funny 2 (Funy2)	Alternates between high pitch and low
	pitch.
Funny 3 (Funy3)	Adds vibrato and changes the pitch from
	low to high.

•Avoid assigning the same sampled sound (tone number 671 to 675) to the keyboard for play along and for looped play. Doing so will cause, the Loop 1 effect to be applied to the keyboard tone while looped play of the sampled sound is being performed.

Incorporating a Sampled Sound into a Drum Set (Drum Sampling)

You can use the procedure to change the drum sounds that are assigned to each keyboard key.

•You can store up to three drum sets and store them as tone numbers 676, 677, and 678. Simply select the tone number where the drum set you want is located to assign the drum set sounds to the keyboard.

1.Press bs. bs lights.

2.Press bt and then use cl (10-key) to enter the tone number (676, 677, or 678) for the drum set whose sounds you want to change.

N o D a t a

Lights

•In place of the above steps, you could press 6 and bs at the same times and then select a tone number.

3.Press 6.

N o Da t a

Flashes

English

E-19