Assembly Instructions
Caution
•This stand should be assembled by two people working together.
•When assembling the stand, you should have the piano standing up with its back facing downwards, as shown in Figure 3.
•Do not remove the tape securing the keyboard cover in place until assembly is complete. Removing the tape can cause the keyboard cover to open and close during assembly, creating the risk of personal injury to your hands and fingers.
•During assembly, be sure to exercise sufficient caution to avoid personal injury.
IMPORTANT!
•Be sure to assemble the stand on a flat surface.
•This stand does not include any of the tools required to assemble it. You should have a large Phillips head (+) screwdriver on hand for assembly.
•Check the items that come with the unit to make sure that everything shown in Figure 1 (A through F) is included. All screws are in a plastic bag inside of the packing card- board.
Figure 1 | B Side panel |
cSpeaker box
8 ····· D Screws 8
8 ····· E Screw caps 8
A Side panel
1 ····· F Cable clip 1
•Before starting assembly of the stand, divide the polystyrene foam packing material into four parts (Figure 2).
Figure 2
Assembling the Stand
When assembling the stand, you should have the piano standing up with its back facing downwards.
PREPARATION
•Use the four pieces of polystyrene foam to secure side panels A and B in place. There should be some space between the edges of the side panels and the floor as shown in Figure 3.
•If you do not have any packing material available, use a magazine or some other thick item.
Figure 3
Polystyrene foam
C
AB
Polystyrene foam
| ||
PS3000_e_26_31.p65 | 27 | 03.10.8, 2:22 PM |