Tape guide
If the tape is not passing through the tape guide, reposition it as shown in the illustration.
Check for bends and damage here.
Stopper

Loading and Removing a Tape Cartridge

A tape cartridge is required when printing tape labels.You should use only the special tape cartridges that are specified for this printer.

To load a tape cartridge

1.Pressto turn off the printer.

2.Press the cassette cover release and open the cover.

3.Remove the stopper from the tape cartridge.

4.Check to make sure that the leading edge of the tape is not bent.

If it is, use a pair of scissors to trim away the bend portion.

5.Make sure that the tape is passing properly through the tape guide.

6.Pull the tape out about 3cm (1 3/16").

Tape

Ink ribbon (under the tape)

Important!

Once tape is pulled out, there is no way to get it back into the cartridge.

Never use excessive force when pulling on the tape. Doing so can cause the ink ribbon to break, creating the risk of malfunction.

7.Check to make sure there is no slack in the ink ribbon.

Ink ribbon

Important!

Loading the tape cartridge into the printer while the ink ribbon is slack can cause the ink ribbon to break, creating the risk of malfunction.

Removing Slack from an Ink Ribbon

If there is slack in the ink ribbon, use a pencil or

a

similar object to rotate the right upper spindle in

 

the direction indicated by arrow "a" in the illustra-

 

tion. Keep rotating until the lower left spindle starts

 

to rotate in the direction indicated by arrow "b".

 

The label tape will not move while you are taking

b

up ink ribbon slack.

 

13E