To preview label contents before printing

1.After performing the procedure under “To create a tape label” above, press

PREVIEW.

This causes the contents of the label to scroll on the display.

Note that the above step cannot be performed if you do not have a tape cartridge loaded in the printer.

2.To pause scrolling of the label contents at any point, press SET.

Press SET again to resume scrolling.

To stop the preview, press ESC.

Note

Characters or illustrations with very fine lines may not appear correctly on the preview screen.

To print a tape label

1.After performing the procedure under “To create a tape label” (and “To preview label contents before printing”, if you want), check to make sure that the tape cartridge is loaded properly and that nothing is blocking the tape outlet.

2.Use and to select PRINT, and then press SET.

3.Use (increase) and (decrease) to specify the number of copies you want to print, from 1 to 100.

Here we will specify one copy.

You can also use the number keys to input a value. Note that you cannot specify 0 here.

4.Press .

5.Use and to specify the tape cut mode.

When you want to do this:

Select this tape

See this page of

 

cut mode:

the User’s Guide:

 

 

 

Print without cutting the

CONT HALF CUT

38

backing paper between

 

 

labels

 

 

 

 

 

Cut between labels

FULL+HALF CUT

39

 

 

 

Print on iron transfer

FULL CUT

39

tape

 

 

 

 

 

Print on magnetic tape or

UNCUT

39

reflective tape

 

 

 

 

 

Here we will select CONT HALF CUT.

See page 38 of the User’s Guide for more information about tape cut modes.

E24