Casio XJ-A235V System Admin Page Settings, System Admin > Setup Settings, System Admin > Change Password

System Admin Page Settings

System Admin > Setup Settings

Setting Name		Description
IP Setup	IP Address	Specifies the projector IP address.
		Initial Default: 192.168.100.10
	Subnet Mask	Specifies a subnet mask value, which specifies the IP address range of the subnet
		to which the projector belongs.
		Initial Default: 255.255.255.0
DHCP Setup	Auto/Disable	Specifies whether an IP address should be assigned automatically to a computer
		connected to the projector via wireless LAN. “Auto” causes an IP address to be
		assigned automatically, while “Disable” turns off auto assignment.
		Initial Default: Auto
	Starting IP Address	Specifies the start point of the range of IP addresses that are assigned
		automatically to computers. This setting is available only while “Auto” is selected
		for the DHCP Auto/Disable setting.
		Initial Default: 192.168.100.11
	Ending IP Address	Specifies the end point of the range of IP addresses that are assigned
		automatically to computers. This setting is available only while “Auto” is selected
		for the DHCP Auto/Disable setting.
		Initial Default: 192.168.100.254
Wireless Setup	SSID	Wireless network ID name. This is normally referred to as the SSID, ESS-ID, or
		network name. Up to 24 single-byte alphanumeric characters can be entered.
		Initial Default: casiolpj_default1 (casiolpj_default2 and casiolpj_default3 also are
		built into the projector.)
	SSID Broadcast	Specifies whether SSID information broadcasting is enabled or disabled.
		Initial Default: Enable
	Channel	Specifies the channel used for wireless LAN communication. Selecting “Auto”
		causes auto selection of a channel that is appropriate for the current
		communication environment. To specify a channel number, select channel number
		1 through 11 from the list that appears when you click the [] button to the right of
		the channel number.
		Initial Default: Auto
	Security	Specifies the security protocol. For more information, see “To configure security
		settings” (page 21).
		Initial Default: WPA-PSK AES
	Passphrase/WEP	Specifies the passphrase or WEP key in accordance with the security protocol
	Key	selected with “Security” above. For more information, see “To configure security
		settings” (page 21).
	IEEE 802.11n	Specifies whether wireless LAN standard IEEE 802.11n is enabled.
		Initial Default: Enable
	Channel Width	Specifies either “20MHz” or “Auto” for the IEEE 802.11n channel width.
		Initial Default: 20MHz
Show User Name Display		Specifies whether the computer’s user name should appear on the projection
		screen when projection starts from a computer connected to the projector via
		wireless LAN.
		Initial Default: On (User name displayed.)

System Admin > Change Password

Setting Name	Description
New Password	For input of the new password when logging in to the System Admin page.
Reinput password	Initial Default: admin

36