CDA RV 700 installation instructions Inside of oven, Replacing the oven light

Inside of oven

The oven should always be cleaned after use when it has cooled down. The cavity should be cleaned using a mild detergent solution and warm water. Suitable proprietary chemical cleaners may be used after first consult- ing with the manufacturers recommen- dations and testing a small sample of the oven cavity. Abrasive cleaning agents or scouring pads/cloths should not be used on the cavity surface.

NOTE: The manufacturers of this appli- ance will accept no responsibility for damage caused by chemical or abra- sive cleaning.

Let the oven cool down and pay special attention no to touch the hot heating elements inside the oven cavity.

Replacing the oven light

Before any maintenance is started involving electrical parts of the appli- ance, it must be disconnected from the power supply.

–Let the oven cavity and the heating elements cool down;

–Unscrew the protective cover C (fig. 19);

–Unscrew and replace the bulb B with a new one suitable for high tempera- tures (300°C) having the following specifications: 230-240V 50 Hz, 15W, E14 and same power (check watt power as stamped in the bulb itself) of the replaced bulb.

–Refit the protective cover.

NOTE: Oven bulb replacement is not covered by your guarantee.

B	C
Fig. 19
	27