2.Video Input Jack
This jack accepts the yellow RCA plug from the SDBSC cable and applies the video signal from the source component (Example VCP, DVD etc.).
3.Source Component 12 VDC Output
This jack accepts the black barrel type power con- nector from the SDBSC cable. (This supplies power to the source component).
4.IR Repeater Output
This jack accepts the 3.5mm mono plug of the SDBSC. (NOTE: The IR repeater in this system may not work with
5.Power Supply Input
This jack accepts the Molex
1 | 2 | 1 – GN D |
2 | ||
1 | 1 | 2 – CON STA N T (YELL OW ) |
3 | ||
|
| 3 – IG NITION (R ED ) |
OPERATING THE SDB45 SYSTEM
(Without the Master Control Station)
Control Stations:
A.Turning the SDB45 On and Off:
1.Turn the ignition key to the ON position.
2.Press the Main Power on the Control Station (The Power symbol will light up bright red and
8
the volume up/down buttons and the Select button will illuminate). (Note: Some LCD screens such as the LCM0505, 0565, 4000 and 5000 require that the power button on the screen be turned on in order to view program material after the Main Power button on the control station is pressed).
3.Select the source you wish to view by pressing the “S” button on the control station. (Note: Pressing and holding the “S” button for more than six seconds will pass infrared control of the sources to the control station. The source LED will start blinking to indicate that that con- trol station has control. A remote control can then be used to control that video source when it is pointed at the control station.
4.Turn on the source to be used (VCP, DVD etc) either manually or by the remote control for that device.
5.Plug in a set of wired headphones into the con- trol station to listen to the selected source. Use the volume up (+) and volume down
6.Repeat steps
