Leak Testing
DANGER
To prevent fire or explosion hazard:
·Do not smoke while performing a leak test.
·Do not permit any sources of ignition in the area when testing for leaks.
·Perform leak tests outdoors only.
·Never perform a leak test near a fire or flame.
How to Check the Fuel-Supply System for Gas Leaks
1.Mix a solution of equal parts mild detergent or liquid soap and water.
2.Turn off the
3.Turn the top knob of the
4.Apply the soap solution to all connections of
If no soap bubbles appear, the grill is fine for use.
If bubbles form at the connections, there is a leak. In case of a leak, try tightening the joint. If necessary, replace the faulty part with a replacement part recommended by the manu- facturer.
5.Turn off the knob on
6.Turn on the
7.Wash off soapy solution with cold water and towel dry.
WARNING! Do not attempt to repair the cylinder valve. If it becomes damaged, the cylinder must be replaced.
If you are unable to stop a leak, shut off the gas supply at the cylinder valve. Remove the cylinder from the grill. Call a gas appliance ser- viceman or L.P. gas dealer. Do not use appli- ance until the leak is fixed.
Perform a leak test each time the
Perform a leak test at least once each year whether the L.P. gas supply cylinder has been disconnected or not.
Have a dealer check the cylinder for deteriora- tion after 10 years, according to DOT regula- tions. Immediately replace cylinder if any is found.
IMPORTANT! Inspect the
Leak Testing the Fuel
Supply System
Arrows denotes primary areas
to check.
24
