Cisco WAP551 and WAP561 Wireless-N

2

Access Point Features

Front Panel

The front panel of the devices consists of three lights: Power, WLAN, and LAN. For full descriptions of the colors of the lights and their indications, see “Verifying the Hardware Installation”.

A Kensington lock slot is found under the lights.

Back Panel

The back panel of the devices has an RJ-45 Ethernet Port. Use the Ethernet port to power your device using PoE. It is an auto-sensing, Gigabit Ethernet (802.3) port used to connect your WAP devices to network devices, such as computers, routers, or switches. Cisco strongly recommends using Category 5e or better cable for Gigabit connectivity.

Side Panel

The side panel of the devices has a Reset button. See “Rebooting the Devices or Returning them to their Factory Default Settings” for

information on the Reset button.

Default Settings

 

 

 

Parameter

Default Value

 

 

Username

cisco

 

 

Password

cisco

 

 

LAN IP Address

DHCP address assigned

 

by server

 

 

Fallback LAN IP

192.168.1.245

 

 

Subnetwork Mask

255.255.255.0

 

 

If you are using a Cisco Small Business RV Series router, the default range for the DHCP assigned address is from 192.168.1.100 to 192.168.1.254. Any device connecting to the same LAN will be assigned an IP address in this range.

Cisco Small Business WAP500 Series Wireless Access Point

3

Page 3
Image 3
Cisco Systems WAP561AK9 Cisco WAP551 and WAP561 Wireless-N, Access Point Features, Front Panel, Back Panel, Side Panel