Chamberlain 3453135556 manual Wall Control Installation, Finding the mounting location, Mounting

4WALL CONTROL INSTALLATION

WARNING

Verify there is no power to the operator before installing wall control wires.

CAUTION

Use of any wall control other than the type supplied will prevent the light from working and could cause the door to operate on its own.

Cut or pinched wires can cause the wall control to stop working. When using the insulated staples, make sure you only pound them in as far as needed to hold the wire snugly.

1.Finding the mounting location.

•Pick a convenient location for mounting wall control.

–Location you choose should be in direct sight of door.

–It should be at least 5' above floor to prevent small children from operating door.

–It must be away from any moving parts. (You should not be able to reach the door while standing at wall control.)

2.Wiring.

•Run wire from power head to wall control.

•Securely fasten to ceiling using insulated staples provided.

•Split and strip ends of wire (Fig. 4-5).

•On power head:

–Attach the striped wire to terminal #1 and white wire to terminal #2 (Fig. 5-1).

•On back of wall control:

–Attach striped wire to terminal “B”, and white wire to terminal “W.” (Fig. 5-2).

3.Mounting.

•Fasten wall control to wall with 2 screws (either wall button or console use 33) (Fig. 5-3).

[33] #6 x 1-1/4"

•Remove protective backing from “entrapment” warning label (Fig. 5-4).

– Stick label on wall near wall control.

NOTE: Additional wall controls are available from your dealer. ONLY ONE OF YOUR WALL CONTROLS MAY BE THE LIGHTED TYPE. If you have a lighted wall control, all your additional controls must be un-lighted. More than one lighted wall control per operator will cause a malfunction.

FOR HELP-1.800.929.3667 OR OVERHEADDOOR.COM

1

2

FIG. 5-1 Terminal attachments at power head.

button console

FIG. 5-2 Wall control wire attachment.

FIG. 5-3 Mounting wall control.

17

FIG. 5-4 Entrapment warning label.