2. PRINTER SETUP
ENGLISH VERSION
2.2 Connecting the Power Cord
2.1 Installation
CAUTION!
As the enclosure of this product is made from plastic, do not install the printer where it might be exposed to oil or solvent.
2.2Connecting the Power Cord
CAUTION!
As a Power Cord is not supplied with the printer, please purchase an approved on that meets the safety standard of each country. (Refer to APPENDIX 3.)
To insure the best operating environment, and to assure the safety of the operator and the equipment, please observe the following precautions.
•Operate the printer on a stable, level, operating surface in a location free from excessive humidity, high temperature, dust, vibration or direct sunlight.
•Keep your work environment static free. Static discharge can cause damage to delicate internal components.
•Make sure that the printer is connected to a clean source of AC Power and that no other high voltage devices that may cause line noise interference are connected to the same mains.
•Assure that the printer is connected to the AC mains with a three- prong power cable that has the proper ground (earth) connection.
1.Make sure that the printer Power Switch is in the OFF ({) position. Connect the Power Cord to the printer as shown in the figure below
Power Switch | Power Cord |
2.Plug the other end of the Power Cord into a grounded outlet as shown in the figure below.
Power Cord | Power Cord |
|
[Example of US Type] | [Example of EU Type] |
E2- 2
