7. SUPPLY SPECIFICATIONS

ENGLISH VERSION EO1-33048

7.4 Care/Handling of Media and Ribbon

7.3 Recommended Media and Ribbon Types (Cont.)

Ribbon type

Description

Vellum wax ribbon

This ribbon is mainly used for vellum paper and labels. It has a very

 

high ink density to cope with uneven printing surface

Standard wax ribbon

Good match for coated paper (Matt coat and glossy coat).

Smear-less ribbon (Wax resin ribbon)

Good match for coated paper. The printed image will resist water and

 

light rubbing.

Scratch and solvent resistance ribbon

Very good match for plastic films (synthetic paper, PET, polyimide,

 

etc.)

 

Scratch and solvent resistance

 

Heat resistance with PET and polyimide.

Combination of Media and Ribbon

Media type

Vellum paper and label

Coated paper

Ribbon type

 

 

Vellum wax ribbon

{

 

Standard wax ribbon

 

{

Smear-less ribbon (wax-

 

{

resin ribbon)

 

 

 

Scratch/solvent

 

 

resistance ribbon

 

 

Plastic films

{

{: Good match

7.4 Care/Handling of Media and Ribbon

CAUTION!

Be sure to carefully review and understand the Supply Manual. Use only media and ribbons that meet specified requirements. Use of non-specified media and ribbons may shorten the head life and result in problems with bar code readability or print quality. All media and ribbons should be handled with care to avoid any damage to the media, ribbons or printer. Read the guidelines in this section carefully.

Do not store the media or ribbon for longer than the manufacturer’s recommended shelf life.

Store media rolls on the flat end. Do not store them on the curved sides as this might flatten that side causing erratic media advance and poor print quality.

Store the media in plastic bags and always reseal after opening. Unprotected media can get dirty and the extra abrasion from the dust and dirt particles will shorten the print head life.

Store the media and ribbon in a cool, dry place. Avoid areas where they would be exposed to direct sunlight, high temperature, high humidity, dust or gas.

The thermal paper used for direct thermal printing must not have specifications which exceed Na+ 800 ppm, K+ 250 ppm and Cl- 500 ppm.

Some ink used on pre-printed media may contain ingredients which shorten the print head’s product life. Do not use labels pre-printed with ink which contain hard substances such as carbonic calcium (CaCO3) and kaolin (Al2O3, 2SiO2, 2H2O).

For further information, please contact your local distributor or your media and ribbon manufacturers.

E7- 5

Page 95
Image 95
Toshiba BSA4TMGS12QMR, B-SA4TP Care/Handling of Media and Ribbon, Ribbon type Description, Combination of Media and Ribbon