Toshiba BSA4TMGS12QMR, B-SA4TM-GS12-QM-R, B-SA4TP manual Setting the Black Mark Sensor position

2. PRINTER SETUP

ENGLISH VERSION EO1-33048

2.3 Loading the Media

2.3Loading the Media (Cont.)

NOTES:

1.Be sure to set the Black Mark Sensor to detect the centre of the black mark, otherwise a paper jam or no paper error may occur.

2.After adjusting the Black Mark Sensor position, align the Upper Feed Gap Sensor with the Lower Feed Gap Sensor. This is because a paper end is detected by the Feed Gap Sensor.

Setting the Black Mark Sensor position

When using media with black marks, the Black Mark Sensor is used to detect a print start position.

(1)Push the Upper Sensor Lever inside and open the Upper Sensor Ass’y.

(2)Check the reverse side of the media for the black mark position.

(3)Slide the Lower Sensor Tab to move the Black Mark Sensor so that it is in line with the centre of the black mark on the media.

( ‡ indicates the position of the Black Mark Sensor).

It may be easier to move the Lower Sensor Tab if you use a pen inserting its tip into the pinhole of the tab.

Pinhole

Black Mark

Sensor Lower Sensor

Tab

(4)Lower the Upper Sensor Ass’y until the Upper Sensor Lever clicks in position.

E2- 7