Toshiba BSA4TMGS12QMR, B-SA4TM-GS12-QM-R, B-SA4TP Detection Area of the Transmissive Sensor, Label

7. SUPPLY SPECIFICATIONS

ENGLISH VERSION EO1-33048

7.1 Media

NOTES:

1.To ensure print quality and print head life use only TOSHIBA TEC specified media.

2.The ratio of a label length to a gap length must be a minimum of 3 to 1 (3:1).

3.Backing paper must be wider than a label; the distance between the edge of the backing paper and that of a label should be at least 1.5 mm.

4.Use of the tag paper of 25 mm to 50 mm in width, and 171 µm to 263 µm in thickness may shorten the platen life.

5.When using a label stock in cut mode, be sure to cut the gaps. Cutting labels will cause the glue to stick to the cutter, which may affect the cutter performance and shorten the cutter life.

6.To tear off printed media in batch issue easier, set the Auto Forward Wait function (FORWARD WAIT parameter) to ON in the system mode. When this function is effective, the printer stops feeding the printed media past the strip shaft. In case of a label stock, however, if a next label is issued without tearing off the printed label, the label may peel while it is fed backward, causing a printer failure.

7.1.2 Detection Area of the Transmissive Sensor

The Transmissive Sensor is movable from the centre to the left edge of media.

The Transmissive Sensor detects a gap between labels, as illustrated below.

<Label>							Centre of media
				Area to be detected.
	Sensor position
								Print side
Min. 2.0 mm					Label
					Gap
					Label
		Min. 12 mm				Media feed direction
						Sensor is movable
						within this range.
<Tag paper with square holes>
							Centre of media
	Sensor position							Print side
								Square holes
	Min. 2.0 mm							(Round holes are not acceptable.)
			Min. 12 mm
								Media feed direction
	Round hole
						Sensor is movable
	Min. Ø 2.5mm					within this range.

E7- 2