Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The door will open and close when you press the large push button.

Below are instructions for programming your opener to operate with additional Security✚® remote controls.

— — — — — — — —

1. Press and hold the button on the hand-held remote* that you wish to operate your garage door.

2. While holding the remote button, press and hold the LIGHT button on the Motion Detecting Control Panel.

3. Continue holding both buttons while you press the push bar on the Motion Detecting Control Panel (all three buttons are held).

4. Release buttons when the motor unit lights blink. It has learned the code. If light bulbs are not installed, two clicks will be heard.

To Erase All Codes From Motor

Unit Memory

To deactivate any unwanted remote, first erase all codes:

Press and hold the “learn” button on motor unit until the learn indicator light goes out (approximately 6 seconds).

All previous codes are now erased. Reprogram each remote or keyless entry you wish to use.

*3-Button Remotes

If provided with your garage door opener, the large button is factory programmed to operate it. Additional buttons on any

Security✚® 3-Button remote or mini-remote can be programmed to operate other Security✚® garage door openers.