INSTALLATION STEP 5
Install the Single Button
Control Station
1.Remove the control station cover.
2.Fasten the control station to the wall at least 5’ (1.5 m) above the ground. The installation surface must be smooth and flat.
3.Select appropriate knockout and run the wires to the operator.
4.Connect wires to the control station and replace the control station cover.
5.Fasten the warning placards to the wall.
To prevent possible SERIOUS INJURY or DEATH from electrocution:
•Be sure power is not connected BEFORE installing door control.
•Connect ONLY to 24 VOLT low voltage wires.
To prevent possible SERIOUS INJURY or DEATH from a closing door:
•Install door control within sight of door, out of reach of children at a minimum height of 5 feet (1.5 m) and away from ALL moving parts of door.
•NEVER permit children to operate or play with door control push buttons or remote controls.
•Activate door ONLY when it can be seen clearly, is properly adjusted and there are no obstructions to door travel.
•ALWAYS keep door in sight until completely closed. NEVER permit anyone to cross path of closing door.
DO NOT EXCEED 10 DOOR OPERATIONS PER HOUR.
FASTEN LABEL ADJACENT TO DOOR.
NE PAS FAIRE FONCTIONNER LA PORTE PLUS DE 10 FOIS PAR HEURE.
FIXER L’ÉTIQUETTE PRÈS DE LA
PORTE.
WARNING
Moving Door Can Cause Serious Injury or Death
Keep Clear! Door May Move at any Time
Without Prior Warning
Do Not Let Children Operate the Door or Play
in the Door Area
Factory installed jumper must be in place for proper operation. Operator will not function without the jumper.
WHT/RED
WHT
Door Control
Connections
SingleButtonControlStation
Keep Door in Sight at all Times When Door is Moving
10