ADJUSTMENT STEP 2
Set the Force
The force setting measures the amount of force required to open and close the door.
1.Push the purple button twice to enter into the Force Adjustment Mode. The LED will flash quickly.
2.Push the door control or programmed remote control. The door will close (DOWN).
3.Push the door control or programmed remote control again. The door will open (UP).
4.Push the door control or programmed remote control a third time to close the door (DOWN).
The LED will stop flashing when the force has been programmed.
The door must travel through a complete cycle, up and down, in order for the force to be set properly. If the garage door opener cannot open and close the door fully, inspect the door to ensure that it is balanced properly and is not sticking or binding.
If the door is not stopping exactly where you would like it, repeat Program the Travel Limits.
18
Without a properly installed safety reversal system, persons (particularly small children) could be SERIOUSLY INJURED or KILLED by a closing door.
•NEVER learn forces or limits when door is binding or sticking. Repair door first
•Too much force on door will interfere with proper operation of safety reversal system.
•After ANY adjustments are made, the safety reversal system MUST be tested. Door MUST reverse on contact with
Figure 1 |
| Black | Figure 2 |
| LED |
| |
| Button |
| |
|
| BLACK | |
|
|
| |
|
|
| Push Purple button |
|
|
| twice to enter |
|
|
| unit into Force |
|
|
| Adjustment Mode |
Purple |
|
| PURPLE |
Button |
|
|
|
Figure 3