SECURITY✚Multi-Function Door Control - Model 58LM (OPTIONAL)
27
Children operating or playing with a garage door
opener can injure themselves or others.
The garage
door could close and cause serious injury or death.
Install the door control (or any additional push
buttons) out of the reach of children and away from
all moving parts of the door and door hardware,
but
where the garage door is visible.
Do not allow
children to operate the push button(s) or the remote
control transmitter(s).
A moving garage door could injure someone under
it.
Activate the opener only when the door is
properly adjusted, you can see it clearly, and there
are no obstructions to door travel.
• Strip 1/4" of insulation from one end of the bell wire;
connect the wire to the two screw terminals on the
back of the door control panel as follows: white to 2
and white/red to 1. (NOTE: If “Lock” and “Light”
buttons do not function after completing
installation, reverse the connections.)
• Locate the door control within sight of the door
at a minimum height of 5 feet where small
children cannot reach, and away from all
moving parts of the door and door hardware.
Fasten the Door Control Panel securely with
6ABx1" screws. If installing into drywall, drill 5/32"
holes and use the anchors provided.
• Run the bell wire up the wall and across the ceiling
to the opener. Use insulated staples to secure the
wire in several places. Be careful not to pierce the
wire with a staple, thereby resulting in a short.
• Connect the bell wire to the opener terminal screws
as follows: white to 2 and white/red to 1.
WARNING
NOTICE: To ensure the proper functioning of your new
Garage Door Opener, please remove all old or previous
push buttons/door control panels.
2-Conductor
Bell Wire
Door Control
Push Bar
LIGHT
LOCK
Multi-Function
Door Control Panel
Light Button
Lock Button
-2
-1
Multi-Function
Door Control Panel
Terminal Screws 2-Conductor
Bell Wire
KG KG
1
3
9
7
5
1
3
9
7
5
23
1
Opener
Terminal
Screws
Antenna
Back Panel
of Opener
RED-1 WHT-2 BLK-3
The Door Control Push Bar: Press to open or close
the door. Press again to
reverse
the door during the
closing cycle or to
stop
the door while it's opening.
Light Feature: Press the Light button. If the opener
light is
off,
it will turn
on.
If the opener light is on, (even in the 4-1/2 minute
automatic cycle) it will turn
off.
But if you use the Light button to turn the light
on
and then activate the opener, the light will turn
off
after 4-1/2 minutes.
The Light Feature will not turn the opener light off
when the door is in motion.
Lock Feature: Designed to prevent operation of the
door from portable remote controls. However, the
door will
open
and
close
from the Door Control push
bar and from the Keylock and the Keyless Entry
Accessories.
To Activate:
Press and hold the Lock button for
2 seconds. The push bar indicator light will flash as
long as the Lock is
on
.
To Turn Off:
Press and hold the Lock button again
for 2 seconds. The indicator light will stop flashing.
Normal operation will resume. The Lock feature will
also turn off whenever the "Smart" button on the
opener end panel is activated.