INSTALLATION STEP 4
Position the Opener
SECTIONAL DOOR ONLY
A 2x4 laid flat is convenient for setting an ideal
•Raise the opener onto a stepladder. You will need help at this point if the ladder is not tall enough.
•Open the door all the way and place a 2x4 laid flat on the top section beneath the rail.
Trolley
Release Arm
ENGAGED | RELEASED |
To prevent damage to garage door, rest garage door opener rail on 2x4 placed on top section of door.
•If the top section or panel hits the trolley when you raise the door, pull down on the trolley release arm
to disconnect inner and outer sections. Slide the outer trolley toward the motor unit. The trolley can remain disconnected until Installation Step 12 is completed.
| Rail |
Door | 2x4 is used to determine |
| the correct mounting height |
| from the ceiling |
INSTALLATION STEP 5
Hang the Opener
Two representative installations are shown. Yours may be different. Hanging brackets should be angled (Figure 1) to provide rigid support. On finished ceilings (Figure 2), attach a sturdy metal bracket to structural supports before installing the opener. This bracket and fastening hardware are not provided.
1.Measure the distance from each side of the motor unit to the structural support.
2.Cut both pieces of the hanging bracket to required lengths.
3.Drill 3/16" pilot holes in the structural supports.
4.Attach one end of each bracket to a support with
5.Fasten the opener to the hanging brackets with
6.Check to make sure the rail is centered over the door (or in line with the header bracket if the bracket is not centered above the door).
7.Remove the 2x4. Operate the door manually. If the door hits the rail, raise the header bracket.
8.Grease the top and underside of the rail surface where the trolley slides with rail grease.
HARDWARE SHOWN ACTUAL SIZE
Lag Screw
Hex Bolt |
| Lock Washer 5/16" |
Nut |
To avoid possible SERIOUS INJURY from a falling garage door opener, fasten it SECURELY to structural supports of the garage. Concrete anchors MUST be used if installing ANY brackets into masonry.
Structural
Supports
Figure 1
Lag Screws
Measure
Distance
Bolt
Lock Washer 5/16"
Nut
Hidden Support | FINISHED CEILING |
| Lag Screws |
| |
Bracket | (Not Provided) |
Bolt | |
(Not Provided) | Lock Washer 5/16" |
| Nut |
Figure 2
Bolt
Lock Washer 5/16"
Nut
11