INSTALLATION STEP 11
Fasten the Door Bracket
A horizontal brace should be long enough to be secured to 2 vertical supports. A vertical brace should cover the height of the top panel.
The illustration shows one piece of angle iron as the horizontal brace. For the vertical brace, 2 pieces of angle iron are used to create a
•Center the door bracket on the previously marked vertical guideline used for the header bracket installation.
•Position the bracket on the face of the door within the following limits:
A)The top edge of the bracket
B)The top edge of the bracket directly below any structural support across the top of the door.
•Mark and drill 5/16" left and right fastening holes. Secure the bracket as shown in Figure 1 if there is vertical reinforcement.
Fiberglass, aluminum or lightweight steel garage doors WILL REQUIRE reinforcement BEFORE installation of door bracket. Contact your door manufacturer for reinforcement kit.
If your installation doesn't require vertical reinforcement but does need top and bottom fastening holes for the door bracket, fasten as shown in Figure 2.
HARDWARE SHOWN ACTUAL SIZE
Header
Bracket
Door Bracket Location
Vertical
Centerline
of Garage
Door
Horizontal and vertical reinforcement is needed for lightweight garage doors (fiberglass, aluminum, steel doors with glass panel, etc.). (Not Provided)
Vertical
Reinforcement
Vertical
Centerline of
Garage Door
Door
Bracket
Figure 1
Inside Edge of Door or
Reinforcement Board
Door
Bracket
Door
Bracket
Plate
Figure 2
18