INSTALLATION STEP 12
Connect Door Arm to Trolley
Follow instructions which apply to your door type as illustrated below and on the following page.
SECTIONAL DOORS ONLYïMake sure garage door is fully closed. Pull the emergency release handle to disconnect the outer trolley from the inner trolley. Slide the outer trolley back (away from the pulley) about 8" (20 cm) as shown in Figures 1, 2 and 3.
•Figure 1:ñFasten straight door arm section to outer trolley with the 5/16"x1" clevis pin. Secure the connection with a ring fastener.
ñFasten curved section to the door bracket in the same way, using the
ñBring arm sections together. Find two pairs of holes that line up and join sections. Select holes as far apart as possible to increase door arm rigidity.
•Figure 3, Hole alignment alternative:ñIf holes in curved arm are above holes in straight arm, disconnect straight arm. Cut about 6"
(15 cm) from the solid end. Reconnect to trolley with cut end down as shown.
ñBring arm sections together.
ñFind two pairs of holes that line up and join with bolts, lock washers and nuts.
ïPull the emergency release handle toward the opener at a 45° angle so that the trolley release arm is horizontal. Proceed to Adjustment Step 1, page 27. Trolley will
HARDWARE SHOWN ACTUAL SIZE
Nut
|
|
|
| Clevis Pin |
| Hex Bolt |
|
|
|
|
| ||
Clevis Pin |
|
|
| |||
| ||||||
5/16"x1" (Trolley) |
|
|
| |||
Pulley
8" (20 cm) min. 
Trolley
Stop Bolt InnerOuter
TrolleyTrolley
Ring
FastenerClevis Pin
5/16"x1"
Emergency
Release
DoorHandle
Bracket
Straight
Door Arm
Clevis Pin | Curved Door Arm |
|
Figure 1
Pulley
8" (20 cm) min. 
Trolley
Stop Bolt
Lock Washers
Nuts 5/16"
Bolts
Door Bracket
Figure 2
Pulley
8" (20 cm) min. 
Trolley
Stop Bolt
Lock
Washers
Nuts 5/16"
Bolts
Cut this end
Figure 3
25