Channel Plus 5115PAL, 5115HHR Installation of the wall plate Step Two, Connecting a Video Source

Side view

of wall plate

Installation of the wall plate

Step Two

The wall plate mounts using a low voltage ring into a wall cut out. Run a line of Cat 5 wire from the wall plate to the channel injector and connect wires as shown.

Connecting A Video Source

Using any video source, DVD,Satellite or VCR connect it to the wall plate as shown. This video source will be transmitted over the Cat 5 wire to the channel injector.

note:

When using Cat 5 wire

remove the default resistor

that is in pins 3 and 4 of the

wall plate screw terminal

Audio/video connections

*Optional loop out television

or a/v receiver

© 1999

Out to

TVs

pin
1	Bl/W
2	Blue
3	Org/W
4	Orange

Video source

Cat 5 wire

Coax jumper

5	Gr/W		Default
6	Green		resistor
7	Br/W
8	Brown
note:		pin
		1	Green
When using quad wire connect		2	Red
wires only to pins 1, 2, 5 and 6.
Leave the resistor in place
at pins 3 and 4.		5	Black
		6	Yellow

At the channel injector, connect Cat 5 wire as shown. Follow the color coding on the screw terminal.

© 1999	When using only quad wire
	use positions 1, 2, 5 and 6
	and follow color coding.

	blue/white
	pin 1	blue/white
	run the Cat 5 wire	pin 1
4	through the grommet at the
	bottom of the injector

Antenna or

CATV feed

*Use the NORM / LOOP switch to select the proper setting for your application.

Norm/Loop

switch

NORM:

Select NORM when a television or a/v receiver is not used at the wall plate to view the connected source.

LOOP:

Select LOOP when a television or a/v receiver is connected to the wall plate to view the connected source

5