Applying Power and Programming
Step Three
The 5115 series has three different methods for applying power to the system.
Use only one method for applying power.
Method One: Apply power directly to the channel injector with the power supply.
© 1999
power supply
Lower right of
channel injector
Power plug
The green LED in the upper right corner of the injector will be lit showing power is active.
(See power length requirements page 8)
Method Two: Use the power injector to apply power along the Cat 5 or quad wire run. Cut the connecting wire along the run and insert the power injector. Connect the wires using the color coding. Then plug the power supply into the power injector.
power injector
power supply
pin 1
blue/white
cut Cat 5 wire
power plug
The green LED in the upper right corner of the channel injector will be lit showing power is active.
Method Three: Apply power directly at the wall plate.
The green LED in the lower right corner of the wall plate and upper right corner of the channel injector will be lit showing power is active.
power plug
6 | 7 |