The 5115 series is a audio/video distribution system that creates a new channel to add to existing television channels. The new channel carries audio/video from any video source to all the TVs in the home The 5115 was designed to install effortlessly into existing coax home wiring or into new construction.
Contents: Channel Injector
Wall plate
Installation
Step One
Locate the incoming CATV or antenna feed and existing splitter.
(Usually found on the side of the house, in the attic or near the electrical and phone service box)
Remove the lock screw located on the bottom of the channel injector and slide the cover off. Use the mounting holes as shown to affix the channel injector to the wall next to the splitter.
Power Injector
Power Supply
Coax Jumper
The 5115 series is comprised of a wall plate and a channel injector. The channel injector is weather resistant and designed to mount indoors or outdoors close to the incoming CATV or antenna feed. The system uses the existing coax cable distribution in the house
Use mounting
holes on the
bottom plate to attach channel injector to the wall
© 1999 |
Mount the
injector within
4” of the splitter
and only requires a single run of Cat 5.
The 5115 was designed to work with Cat 5 wiring. Although the sys- tem will function with quad wire, Cat 5 delivers the highest quality picture. The Cat 5 allows the use of an automatic line length sensor and picture compensator. Quad wire does not take advantage of this enhancement.
Model Differences:
The model 5115HHR is a high headroom design for CATV and off air antenna feeds only.
The model 5115BID is a
The model 5115PAL is designed to modulate PAL frequencies and use CATV or off air antenna feeds.
Installation:
First, locate the incoming CATV or antenna feed and install the channel injector at that location.
Second, install the wall plate at the desired location and run Cat 5 wire from the wall plate to the channel location. Then connect a video source.
Third, apply power and select an unused channel for the 5115 picture to appear on all the televisions.
Disconnect the incoming CATV or antenna feed from the existing splitter and attach it to the channel injector as shown.
Before
Out
to TVs
Incoming CATV or
antenna coax
Now attach the supplied coax jumper back to the existing splitter and tighten all connections with a 7/16” wrench.
After | Mount the | |
1999 | ||
© | injector within | |
| ||
| 4” of the splitter | |
Supplied coax |
| |
jumper goes back |
| |
to splitter |
| |
Incoming CATV or | Out | |
to TVs | ||
antenna coax | ||
|
2 | 3 |