Char-Broil 10201595 manual Place unit in upright position, Fully tighten all screws and nuts

• Place unit in upright position.

5 • Attach small hinge half to smoker chamber using two #10-24 X 1/2” screws and two #10-24flange nuts for each hinge half. Install screws from inside the smoker chamber.

•Attach large hinge half to smoker chamber lid using two #10- 24 X 1/2” screws and two #10-24flange nuts for each hinge half. Install screws from inside the smoker chamber lid.

•Insert top hinge in between bottom hinge and secure using one hinge pin and one hitch pin for each hinge set.

Finger tighten all screws and nuts in this step until all are in place. Once all are in place, close the lid and fully tighten all screws and nuts.

Smoker

Chamber

Lid

Large Hinge Half

Small Hinge Half

Nuts

Smoker

Chamber

Screws

6

•Insert smoke stack through smoker chamber lid, aligning holes.

•Attach using two #10-24 X 1/2” screws and two #10-24flange nuts.

Fully tighten all screws and nuts.

Smoke Stack

Hinge Pin

Hitch Pin

NOTE: Lid side wall shown transparent for clarity

Screw

Nut

on inside of Lid

Page 10