7
NOTE: The temperature gauge may be packed inside of the smokestack to prevent damage during shipping. If so, remove gauge before assembling smokestack to chamber.
•Place fiber washers on handle rods.
•Place the handle assembly into the holes on the front of the smoker chamber door and secure with two
•Repeat on firebox door.
•Insert spring handle through holes on the side of firebox and secure with two
Fully tighten all screws and nuts.
Handle
Fiber
Washer
Spring
Spring
Handle
Nut
Handle Rod | Firebox |
|
Handle
Fiber Washer
Nut
8
•Remove wing nut from temperature gauge.
•Insert temperature gauge though smoker chamber lid hole above handle securing it from the underside with the wing nut removed aligning the gauge settings before fully tightening.
•Insert logo plate though smoker chamb lid holes to the right of the handle, securing it from the underside of the lid with two logo clips.
Temperature
Gauge
Logo Plate
Wing | Logo Clips |
Screw |
Page 11
