COOKING TIPS

Building Your Fire

1.) Stack charcoal briquettes or wood into a pyramid-shaped pile on top of the charcoal grate or ash pan. We recommend using 2 pounds (approximately 20 briquettes) to start your fire.

2.) If using lighter fluid, saturate the charcoal briquettes with lighter fluid and let it soak in for approximately 5 minutes. If using a chimney starter, electric starter, or other type of fire starter, light your fire according to the manufacturer's instructions.

3.) After allowing the lighter fluid to properly soak in, light the pile of briquettes in several

locations to ensure an even burn. Always light the fire with the grill lid open.

Leave lid open until briquettes are fully lit. Failure to do this could trap fumes from charcoal lighter fluid in grill and may result in a flash fire when lid is opened.

4.) Never add charcoal lighter fluid to hot or warm coals as flashbacks may occur causing injury.

5.) You are ready to begin cooking when the pile of briquettes ashes over and produces a red glow (approximately 12 – 15 minutes).

6.) Depending on your cooking method, either leave the briquettes in a pile or spread evenly across the charcoal grate using a long-handled poker.

*Always use caution when handling hot coals to prevent injury.

Know When Your Fire is Ready

Successful charcoal grilling depends on a good fire. The general rule for knowing when your coals are ready for grilling is to make sure that 80 percent or more of the coals are ashy gray. If you have less than that, the coals are not ready, and if all of them are glowing red hot, the fire is probably too hot. Here are a few steps you can take to adjust the temperature of your fire:

-If it is too hot, spread the coals out a bit more, which makes the fire less intense.

-Raise or lower the adjustable charcoal grate.

-Partially close the vents in the grill, which reduces the amount of oxygen that feeds the fire.

-Use the indirect grilling method, with coals to either side of a drip pan and the food over the pan rather than directly over the coals.

-In the event of a severe flare-up, spray the flames with water from a squirt bottle. Be careful, spraying with water tends to blow ashes around and make a mess.

-Add briquettes 2 or 3 at a time to increase the burn time. Allow 10 minutes for coals to ash over before adding more.

THE HEAT OF THE COALS

seconds you can

 

 

 

hold the palm of

 

 

 

your hand 4 inches

 

 

 

above the coals

temperature range (Fº)

visual cues

 

 

 

 

 

HOT COALS

2

400 to 450

 

barely covered with

 

 

 

 

gray ash; deep red glow

MODERATELY HOT

3

375 to 450

thin coating of gray

TO HOT COALS

 

 

 

ash; deep red glow

MODERATELY HOT COALS

4

325 to 375

 

significant coating of

 

 

 

 

gray ash; red glow

MODERATELY COOL COALS 5

300 to 325

 

thick coating of gray

 

 

 

 

ash; dull red glow

Page 4

Page 4
Image 4
Char-Broil 10201595 manual Cooking Tips, Building Your Fire