Char-Broil 11101706 manual Cleaning the Burner Assembly, Proper Engagement, Improper Engagement

CAUTION

SPIDER ALERT!

SPIDER AND WEBS

INSIDE BURNER

Please note that the burner shown is for illustration purposes only. The burner in your product may be different from the one shown.

If you notice that your the appliance is getting hard to light or that the flame isn’t as strong as it should be, take the time to check and clean the venturi’s.

Cleaning the Burner Assembly

Follow these instructions to clean and/or replace parts of burner assembly or if you have trouble igniting appliance.

1.Close gas control knobs and LP cylinder knob and disengage regulator from cylinder.

2.Remove 2 screws (one from each side) connecting control panel to burner assembly.

3.Remove control panel with valve assembly from appliance.

4.Clean inside of burner venturi using a garden hose.

5.Reinstall control panel and valve assembly and attach with 2 screws removed in step 2.

6.Make sure valves are engaged in the burner ventrui as shown below.

VALVE

CONTROL PANEL

SPIDER WEBS

INSIDE VENTURI

BURNER

Proper Engagement

In some areas of the country, spiders or small insects have been known to create “flashback” problems. The spiders spin webs, build nests and lay eggs in the the appliance’s venturi tube(s) obstructing the flow of gas to the burner. The backed-up gas can ignite in the venturi behind the control panel. This is known as a flashback and it can damage your the appliance and even cause injury.

To prevent flashbacks and ensure good performance the burner and venturi assembly should be removed from the the appliance and cleaned before use whenever the the appliance has been idle for an extended period.

Improper Engagement

Page 10