Lighting Instructions:
•Do not lean over appliance while lighting.
•Read all instructions before lighting.
1.Turn the control knobs clockwise until fully tightened in CLOSED position
2.Turn on gas cylinder
3.Place lit match next to inner burner.
4.Turn Right control knob counter clockwise until burner lights.
5.Place lit match next to outer burner.
6.Turn Left control knob counter clockwise until burner lights.
7.If ignition does not occur in 5 seconds, turn the burner control knob CLOSED, wait 5 minutes, and repeat lighting procedure.
If flame is accidently extinguished close all control valves and then repeat lighting instruction.
Burner Flame Check
•Light burner. Turn control knob from OPEN to CLOSED. The Flame height should decrease and then go out. Always check flame prior to each use. If only low flame is seen refer to "Sudden drop or low flame" in the Troubleshooting Section.
High Flame
Low Flame
Turning Appliance Off
•Turn control knob clockwise to the CLOSED position. Turn LP cylinder off by turning
Hose Check
•Before each use, check to see if hose is cut, worn or kinked. Replace damaged hose before using applaince. Clean only with mild soap and water. Use only valve/hose/regulator specified by manufacturer.
WARNING |
Turn control knob and LP cylinder OFF when not in use.
NormalKinked
HoseHose
CAUTION
If ignition does NOT occur in 5 seconds, turn the control knob CLOSED, wait 5 minutes and repeat the lighting procedure. If the burner does not ignite with the valve open, gas will continue to flow out of the burner and could accidently ignite with risk of injury.
General Appliance Cleaning
•Plastic parts: Wash with warm soapy water and wipe dry.
Do not use citrisol, abrasive cleaners, degreasers or a concentrated grill cleaner on plastic parts. Damage to and failure of parts can result.
•Painted surfaces: Wash with mild detergent or
Page 9