8
First, remove the two screws and lock washers factory attached to the sideburner valve bracket. Position sideburner valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.
Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on fascia, making sure “OFF” is on the top. Attach using two
Note: Use left and right holes on fascia to
Screws and Washers attach valve bracket removed from valve bracket
#8-32x3/8” screw Qty.2
4mm lock washer Qty.2
Note: Use upper and lower holes on fascia to attach bezel
Control knob |
|
Sideburner fascia
Sideburner valve bracket
Install bezel with “OFF” at top.
OFF
Hi
4mm
lock washer
Control knob bezel
Valve stem
9
Pull out the four knobs from control panel. Insert temperature gauge stem into the bigger hole above knob bezel,shown A. Make sure the gauge is pushed in as far as it will go, then push the gauge downward until it clips into the panel, as shown
in B/C. | Temperature gauge stem | |||
| ||||
|
|
|
|
|
|
|
| A |
|
Temperature gauge
B
Back of the panel
Knob bezel
Control panel
C
Knob
18