Chariot Carriers 2003 manual Centre-fitting, Side-fitting

Centre-fitting:

Place the Chariot baby seat in the transporter. Lay both the straps that are attached to the bottom of the baby seat around the tensioning strap that you have fitted, and thread the end through as shown in the illustration A.

Illustration A

This should then give a distance of about 8 cm (3 inches) between the baby seat and the tensioning strap.

Pull the baby seat upwards between the fitted telescopic tube and the front fabric assembly or the front wall of the floor pan, and place it in the internal space of the transporter.

Make sure that the front padding of the baby seat is positioned above the telescopic tube.

Side-fitting:

Only the baby seat strap that faces the middle is to be fastened to the tensioning strap, fitted as described above. Then the baby seat is pulled around the telescopic tube.

The outside-facing baby seat strap that is between the vertical frame tube and the fabric cover should be guided around the vertical frame tube, then under the telescopic tube, and finally back up between the telescopic tube and the fabric cover.

Thread through the end of the strap as shown in the above illustration and pull the strap tight.

Inside view

The easiest way of getting the strap tight is by pulling the end of the strap downwards below the seat.

Then in both cases follow steps 1.2.2., 1.2.3., 1.2.5. and 1.2.6. of the fitting instructions.

18