Lay the strap that is on the side of the baby seat facing out of the trailer around the vertical frame tube at the side and over the horizontal diagonal tube and pull it forward again.
Thread the strap as described above through the fastener and pull the strap tight.
Centre-fitting:
Thread both straps that are on the back rest through the fasteners on the baby seat as described above.
1.2.5.2 On all other two seaters
Lay both the straps that are at the top of the baby seat around the top crossbar inside the trailer.
Thread the strap through as
illustrated...
...and pull the strap tight.
For the sport models (Cougar, Cheetah) we recommend folding the basic unit slightly for this step, so as to slacken off the fabric cover. In addition we recommend here not pulling the straps too tight, otherwise once you open the unit out again the baby seat will be under too much tension.
1.2.6 Final step in fitting the seat
Pull all fastening straps tight.
If you want to adjust the seat to a flatter position, loosen both of the top fastening straps and pull the other four straps tight; for an adjustment of greater incline, the procedure is the same but reversed.
Please note:
Make sure you check all belt buckles are tight!
Fitted baby seat ready to use in the centre and side position.
Please note:
Never transport your children without the safety belts being properly and fully adjusted, otherwise your child could be seriously or even fatally injured in the event of an accident!
22
