Configuration | Set the product in DMX mode to control with a DMX controller. | |
(DMX) | 1. | Connect the product to a suitable power outlet. |
| 2. | Turn the product on. |
| 3. | Connect a DMX cable from the DMX output of the DMX controller to the DMX input |
|
| socket on the product. |
Starting Address | When selecting a starting DMX address, always consider the number of DMX channels | |
| the selected DMX mode uses. If you choose a starting address that is too high, you could | |
| restrict the access to some of the product’s channels. | |
| The Intimidator™ Spot LED 150 uses up to 11 DMX channels in its | |
| mode, which defines the highest configurable address to 502. | |
| If unfamiliar with the DMX, download the DMX Primer from www.chauvetlighting.com. | |
| To select the starting address, do the following: | |
| 1. | Press <MODE/ESC> repeatedly until 001 shows on the display. |
| 2. | Press <ENTER>. |
| 3. | Use <UP> or <DOWN> to select the starting address. |
| 4. | Press <ENTER>. |
DMX The Intimidator™ Spot LED 150 has two DMX personalities, a
To choose which DMX personality to use, follow the steps below:
1.Press <MODE/ESC> repeatedly until either 11CH (to choose the
2.Press <ENTER>.
Page 10 of 18 | Intimidator™ Spot LED 150 User Manual Rev. 8 |