Operating Instructions
Midi Operation
The controller will only respond to MIDI commands on the MIDI channel which it is set to full stop. All
MIDI control is performed using Note on commands. All other MIDI instructions are ignored. To stop a
chase, send the blackout on note.
Action
1)Press and hold the MIDI/REC button for about 3 seconds.
2)Select the MIDI control channel (1~16) via the BANK UP/DOWN buttons to set.
3)Press and hold the MIDI/REC button for 3 seconds to save settings.
4)To release MIDI control, press any other button except the BANK buttons during step 2.
Notes
This is the Channel that the controller will receive MIDI note commands.
MIDI NOTE
00 to 07
08 to 15
16 to 23
24 to 31
32 to 39
40 to 47
48 to 55
56 to 63
64 to 71
72 to 79
80 to 87
88 to 95
96 to 103
104 to 111
112 to 119
120
121
122
123
124
125
126
FUNCTION (TURN ON/OFF)
Scenes 1~8 in BANK 1
Scenes 1~8 in BANK 2
Scenes 1~8 in BANK 3
Scenes 1~8 in BANK 4
Scenes 1~8 in BANK 5
Scenes 1~8 in BANK 6
Scenes 1~8 in BANK 7
Scenes 1~8 in BANK 8
Scenes 1~8 in BANK 9
Scenes 1~8 in BANK 10
Scenes 1~8 in BANK 11
Scenes 1~8 in BANK 12
Scenes 1~8 in BANK 13
Scenes 1~8 in BANK 14
Scenes 1~8 in BANK 15
Chase 1
Chase 2
Chase 3
Chase 4
Chase 5
Chase 6
BLACKOUT
Data Transfer
It is possible to transfer the programs stored in one
DMX output of the programmed controller to the DMX input of the other.
Action
1)Source unit: Turn unit Off, press and hold SCANNER buttons 2, 3 and SCENE button 1 then turn unit back On.
2)Destination unit: Turn unit Off, press and hold SCANNER buttons 8, 9 and SCENE button 2 then turn unit back On.
3)Both units are now ready to transmit and receive. Press SCENE buttons 7 & 8 simultaneously on Source unit to begin transmission.
Notes
The display should show TRANSMIT, this indicates it is ready to transmit data.
The display should show RECEIVE, this indicates it is ready to receive data transmission.
17 |
