Operating Instructions
JOY ST ICK SET UP
Because not all intelligent lighting fixtures are alike or share the same control attributes, the
allows the user to assign the joystick the correct pan and tilt channel for every fixture.
Action
1)Press the Program button until the LED blinks.
2)Hold the MODE button and press FINE. The Reverse LED will light.
3)Hold the MODE button again and press FINE. The Assign LED will light.
4)Use BANK and BANK buttons to select either Pan or Tilt.
5)Use the TAP/Display button to switch between the first 8 available channels (8CH) and the second 8 (16CH).
6)Press the button corresponding to the SCANNER button you wish to assign.
7)While holding the MODE button press the scene number that corresponds to the slider which controls the movement.
8)Repeat steps 4 through 7 as necessary.
9)To exit, hold the MODE button and press FINE.
Notes
You will need to repeat this process to enter the Assign Joystick Function.
There are 16 available DMX channels but only 8 can be selected at a time by using the SCENES buttons. The TAP/Display acts like a page button allowing you to have access to the lower 8 channels (8CH) and the top 8 (16CH).
Example: If pan is controlled by slider number 4, press and hold Mode button while pressing Scenes button # 4.
Make sure Assign and Reverse LEDs are off.
REVER SE DM X C H AN NEL AN D JOY ST IC K
Action
1)Press the Program button until the LED blinks.
2)Hold the MODE button and press FINE. The Reverse LED will light.
3)Use BANK and BANK buttons to select either Pan or Tilt. The corresponding LED will light.
4)Use the TAP/Display button to switch between the first 8 available channels (8CH) and the second 8 (16CH).
5)Press the button corresponding to the SCANNER button you wish to assign.
6)Find the slider or you wish to reverse DMX output on.
7)While holding the MODE button, press the scene number that corresponds to the slider you wish to reverse.
8)Repeat steps 4 through 7 as necessary.
9)To exit, hold the MODE button and press FINE.
Notes
If the Reverse LED light does not light up repeat the process until it does.
You may reverse a maximum of 48 channels for 12 scanners.
9 |
