3.SETUP
Lamp
| You will need to install a lamp prior to the initial operation of the fixture. An 800W halogen lamp is |
| included. |
Warning! | When replacing the lamp, please wait 15 minutes after powering down to allow the |
| unit to cool down! Always disconnect from main power prior to lamp replacement. |
| Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp |
| with alcohol and wipe it with a lint free cloth before installation. |
Lamp Installation
1) Unscrew the two thumbscrews (Figure 1).
2) Gently remove the lamp housing from the fixture.
3) Remove the lamp from the socket (Figure 2)
4)Hold the new lamp with a
Insert lamp into socket.
| 5) | Carefully reinsert lamp housing into the |
|
| fixture. |
| 6) | Tighten both thumbscrews |
Note: | It may be necessary to align the lamp after | |
| replacement. See the “Lamp Alignment” | |
| section on the next page for instructions on | |
| how to do this. | |
1
2
SX Gobo Manual | 6 |
