Chauvet E-190WW user manual Operation

Operation

Reset

Performance Power

Output Options

Manual Beam Focus

Control

Rotating the Barrel

Assembly

To reset the OVATION™ E-190WW to the factory default settings, follow the instructions below.

1.Go to the SET main level.

2.Select the REST programming level and then the display becomes blank. Enter the passcode as described in Passcode. After successfully entering the passcode, REST blinks on the display during the reset process.

3.OK appears on the display when finished.

The OVATION™ E-190WW offers three power output options during the cooling of the fixture’s LEDs.

1.Go to the SET main level.

2.Select the PERF programming level.

3.Select from the following options:

∙Select LIVE to cool the LEDs by balancing the use of the fan and the power output level.

∙Select STDO to cool the LEDs by maintaining the use of the fan and limiting the power output level.

∙Select POWR to cool the LEDs by maintaining the use of the fan and allowing full power output.

The OVATION™ E-190WW has a manual focus, which is adjusted as follows.

1.Locate the beam focus knobs at the top and bottom of the barrel assembly.

2.Loosen the knobs by turning them counter-clockwise.

3.Slide the lens tube forward or backward until you achieve the desired focus or beam edge.

4.Tighten the knobs by turning them clockwise, which lock the lens tube’s position.

The OVATION™ E-190WW allows manual rotation of the barrel assembly, as follows.

1.Locate the barrel rotation knobs at the top and bottom of the reflector housing.

2.Loosen the knobs by turning them counter-clockwise. Note: Do not remove the knobs.

3.Rotate the barrel to the desired position, up to 25° in either direction from the centered position.

4.Tighten the knobs by turning them clockwise, which lock the barrel’s position.

Make sure the barrel assembly is oriented with the pattern holder and drop-in iris slots at the top of the product.

OVATION™ E-190WW User Manual Rev. 3 -13-