Chauvet E-190WW user manual Setup, AC Power, AC Plug, Fuse Replacement

Setup

3. Setup

AC Power

AC Plug

Each OVATION™ E-190WW has an auto-ranging power supply that works with an input voltage range of 100~240 VAC, 50/60 Hz. To determine the power requirements for each OVATION™ E-190WW, refer to the label affixed to the product. You can also refer to the Technical Specifications chart in this manual.

The listed current rating indicates the maximum current draw during normal operation. For more information, you may download Sizing Circuit Breakers from the CHAUVET® website www.chauvetpro.com.

Always connect this product to a protected circuit with an appropriate electrical ground to avoid the risk of electrocution or fire.

Never connect this product to a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel serves only as a 0 to 100% switch.

The OVATION™ E-190WW comes with a power input cord terminated with a Neutrik® powerCON® A connector on one end and an Edison plug on the other end (U.S. market). If the power input cord that came with your product has no plug, or if you need to change the Edison plug, use the table below to wire the new plug to the power input cord.

Connection	Wire (U.S.)	Wire (Europe)	Screw Color
AC Live	Black	Brown	Yellow or Brass
AC Neutral	White	Blue	Silver
AC Ground	Green/Yellow	Green/Yellow	Green

Fuse Replacement

Make sure to disconnect the product’s power cord before replacing a blown fuse.

1.Disconnect this product from power.

2.Using a Phillips #2 head screwdriver, unscrew the fuse holder cap from the housing.

3.Remove the blown fuse and replace with another fuse of the same type and rating (T 3.15 A, 250 V).

4.Screw the fuse holder cap back in place and reconnect power.

Always replace the blown fuse with another of the same type and rating.

-6- OVATION™ E-190WW User Manual Rev. 3