3.SETUP
AC Power
This fixture is
To determine the power requirements for a particular fixture, see the label affixed to the back plate of the fixture or refer to the fixture’s specifications chart. A fixture’s listed current rating indicates its average current draw under normal conditions.
Always connect the fixture to a switched circuit. Never connect the fixture to a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only as a 0 to 100% switch.
Always connect the fixture to a circuit with a suitable electrical ground.
Power Linking
This fixture contains power linking via the Edison outlet located in front of the power input cable. Please see the diagram below for further explanation.
The maximum quantity of Sweeper™ LEDs that may be linked is 20 units @ 120V, 33 units @ 230V
Fixture #1
Fixture #2
Fixture #3
Additional power link out
The power linking shown in this document is for the CHAUVET® North American version ONLY! Therefore, it is the customer’s responsibility to check with the Dealer/Distributor regarding power linking on the local version of the product. Connections and availability may change, depending on the power requirements and/or regulations of each country/region.
3. Setup | 6 | 1/12/2011 11:51 AM |
